Water is essential to life. This technique is very useful when you are hunting to survive. People can live up to a week without food, but only two to three days without water. Clean water can be hard to find if you get stranded in the wild or if there is an emergency. If you have to find your own water supply, you must be able to strain out impurities that can make you sick. This article will tell you how to make a
water filter.
1.Gather your supplies. You will be making a
water filter that relies on layers to make dirty water clean. If you plan on drinking this water, you will need to boil it after you have filtered it.Here is a list of what you will need:
• Plastic bottle with a cap
• Craft knife
• Hammer and nail
• Coffee filter
• Large cup or mug (Either one works)
• Activated charcoal
• Sand
• Gravel
• Container to catch the water (jar, cup, mug, etc)
2.Use a craft knife to cut the bottom inch (2.54 centimeters) or so off of the plastic bottle. Stick the knife into the side of the bottle, and start cutting it slowly. You may find that making short, back-and-forth cuts (like sawing) may be easier.
• If you are a child, ask an adult to help you with this step
• Add handle so that you can hang it while it filters the water. Start by poking two holes near the cut edge of the bottle. Make the holes opposite of each other. Thread a piece of string through the two holes. Tie the string in a knot.
3.Use a hammer and nail to punch a hole in the cap. The hole will help slow down the flow of water and make the filter more effective. If you don't have a hammer or nail, use a craft knife to stab an X shape into the bottle cap.
4.Put the coffee filter over the mouth of the bottle and tighten the cap over it. The coffee filter will keep the activated charcoal inside the bottle and keep it from falling out. The cap will hold the coffee filter in place.
5.Put the bottle cap-side-down into a mug or cup. This will help keep the bottle steady while you fill it. If you don't have a cup or mug, then you can place the bottle down on a table. You will need to hold it steady with one hand.
6.Fill the bottom third of the bottle with activated charcoal. If the charcoal comes in large pieces, you will need to break them down into smaller pieces. Do this by putting the chunks inside a bag, and crushing them with a hard object (such as a hammer). You don't want the chunks to be larger than a pea.
• Charcoal can get very dirty. You can keep your hands clean by wearing some gloves.
7.Fill the middle of bottle with sand. You can use any type of sand you want, but avoid using colored craft sand. Colored sand may leak dyes into the water. Try to make the sand layer about as thick as the charcoal layer. The bottle should be a little more than half-way full by now.
• Try using two types of sand: a fine grained sand and a coarse grained sand. The finer sand will go first, on top of the charcoal. The coarse grained sand will go next, on top of the fine-grained sand. This will create more layers for the water to pass through, and help make it cleaner.
8.Fill the rest of the bottle with a gravel. Leave an inch (2.54 centimeters) or so of empty space between the gravel and the cut part of the bottle. Do not fill the bottle all the way with gravel, or the water may spill over if it does not drain fast enough.
• Try using two types of gravel: a fine grained gravel and a chunky gravel. The fine grained gravel will go first, on top of the sand. The chunky gravel will go next, on top of the fine gravel.
