How to update MB SD Connect C4 C5

This post comes with the introduction to updateMB SD Connect Compact 5 /MB SD C4/ SD C4 PLUS.
Step 1: Change file name
There are two storage path for MB SD Connect Compact 4/ new SD C4 plus/ SD C5.
Path 1: C:\Program Files\Mercedes-Benz\SDConnect Toolkit
Path 2: C:\Program Files\Softing\Diagnostic Tool Set 8\8.03\Interfaces\DCDI_DPduApi\eCOM_Toolkit
Please modify the file name of “update_automaticx”, “update_manualx” and “update_specicalx” to “update_automatic”, “update_manual” and “update_specical”, it means remove the last letter of all the three file names.




Restart PC when finish modifying
Note:
1.You need to put 6 AA batteries into MB SD C4 (Item No.SP-100D) and SD C5 (Item No.SP255 ), but you don’t have to install batteries for DOIP MB SD C4 PLUS (Item No. SP100-E) firmware update.
2.Make sure OBD main cable connect to car or 12v power supply
Step 2: Update software
Right click at the right corner and select “Administration”-> “Software update”

Mainly update the following three files in order:
“02_CSD_2_11.zip” -> “01_Bootimage_2_3.zip”-> “03_PmPic29_Cpld13.zip”

That’s all!

2012 Buick new LaCrosse engine idle learning operation method with launch X431 V X431

2012 Buick new LaCrosse engine idle learning operation method on launch X431 V/X431 V+ (pro3) PAD

 

Measured models: Buick LaCrosse 2.4L, Engine Model LAF, 2012 models,

VIN=LSGGF53W2CH1*****

Steps:

1. Select China General V48.90 or later.


2. Select manual selection, note that you can not choose online programming.


3. Select “Buick”.


4. Select year 2012.


5. Select “New LaCrosse”.


6. Select “engine control module”.


7. Select Engine Type 2 “2.4 liters (LAF)”.


8. Select “Configuration/Reset Function”.


9. Select “learning function”.


10. Select “Immediately read in”.


11. A prompt box appears, choose to confirm press Niu, as shown in Figure 10.

12.Enter the function operation interface, display the corresponding data flow value andoperation status value, the command status shows “None”, as shown in Figure 11.

13.Click on the “Reset” button below and the execution will be changed to “Reset”, as shown inFigure 12.

14.The key is closed, click the exit button, the operation is over.