Xentry 03/2021 error “The data are faulty” Solution

Xentry 03/2021 can’t connect and error “The data are faulty”. During the past months, some users feedback this problem, and someone tested and worked out the solution.

Solution:

I checked logs in C:\ProgramData\Mercedes-Benz\logs\Xentry and found the following:

Caused by: com.teradyne.ds.io.MissingPluginException: Could not load file:/C:/Program%20Files%20(x86)/Mercedes-Benz/Xentry/MB_PKW/Baureihe/BR_Templates/ModulEinstieg_Template.gmf

This file has been updated apparently by a recent addon as it now has a newer timestamp.

For me it worked to replace this file with an older copy:

C:/Program%20Files%20(x86)/Mercedes-Benz/Xentry/MB_PKW/Baureihe/BR_Templates/ModulEinstieg_Template.gmf

It looks like a recent addon overwrites this file with a newer version that causes this error message.

Hope it helps!

V202106 MB Star Diagnostic - Xentry 03/2021 error “The data are faulty” Solution – Xentry V202106

Good to know:

Xentry 06/2021 is already tested working fine and available at :

HDD version Win7 Win10

SSD Win7 Win10

https://mbstarscanner.blogspot.com/2021/08/xentry-032021-error-data-are-faulty.html

Launch X431 Guide Function to Set VW Passat 2013 DSG Transmission

After replacing DSG transmission, DSG clutch pack & DSG
mechatronic, the vehicle may get a fault code P175F00: transmission
basic setting not perform.

How to do DSG transmission basic setting?

The procedure is taking VW Passat 2013 as an example, applies to Launch X431 PAD V, X-431 Pad VII, X431 PRO V4.0, X431 Pro3 V4.0.

Having diagnosed systems for fault codes, go back to “Guided Functions”.

Fill in the vehicle basic characteristics including manufacturer, vehicle type, year, model, engine type, press “Start”.

Transmission electronics >> Guided functions >> J743 –
Mechatronic, basic setting >> Continue/ complete >>
Continue/ complete

Follow the instructions to operate:

Note: if the entire transmission is replaced, no basic setting is necessary.

To ensure proper communication between control modules, the installation info must be reset.

Continue/ complete >> 2. transmission basic setting >> Yes

Check Pre-Conditions:

More transmission selector lever to position P.

Apply parking brake.

Switch the engine off.

Switch the ignition on.

Press “Continue/ complete”.

Test requirements have been met.

Basic setting will continue.

Please wait the vehicle diagnostic tester automatically continues…

Basic setting active.

The basic setting is running, please wait…

Note:

During the basic setting, unusually loud gear shifting noises are noticed in the drive train.

Press “Continue/ complete”.

Start the engine…

Please wait…

The basic setting has been performed correctly.

Only when the ignition is switched off and on will the data in the mechatronic be stored.

Switch the ignition off.

Press “Continue/ complete”.

Wait for the control modules shutdown to complete.

Switch ignition on.

Note:

The basic setting is completed with the switching on of the ignition.

In the next test step a test drive for the adaptation of the adaptation values is to be performed.

Finally, let’s drive the vehicle to have a test.

It is normal, done!

Using Launch-X431 Diagnostic Tool to perform DSG transmission basic setting after replacement is easy to be done.